Our TY Series Turbine Oil Purification Systems are being
successfully used by hundreds of industrial companies
which involved in hydropower project, Gulf Fertilizers, Mills and
many more turbine users.
This Turbine Oil Purification Systems are being helped to increase
turbine filter life by removing varnish, particles, sludge formed
in the oil
and stopping its further formation by removing emulsified water and
releasing the gas from the oil.
This type Purification System could clean the oil down to NAS 5,
removing contamination & particles down to 5 microns,
and emulsified water down to less than 60 ppm, ensuring that there
was no valve sticking problem in the governing system.
Customers are unable to achieve these results with the use of a
1.This Oil Purifier can remove contamination down to less than 5
micron, water content down to 60 PPM, air & gases down to 0.1%
and lower oxidised molecules of oil from turbine oils.
2.Removal of free and emulsified water prevents formation of
varnish and bacteria.
3.Turbine oil is 98% base oil and it has approximately 2%
4.By keeping the oil free from water and contamination down to less
than a micron, TY Series Oil Purification Systems protects the
turbine oil additives,
which can then continue to perform their essential functions for a
very long time thereby increasing oil life tremendously.
5.TY Series replaceable filter element uses special filter media
which not only removes particles by depth filtration
but it also has an affinity to remove varnish, sludge and lacquer
from oil by adsorbtion.
6.TY Series filter is unaffected by water and can remove large
quantities of contamination
which makes it a very cost effective tool for removing
contamination from turbine oils.
7.TY Series can be installed directly on any turbine oil reservoir
as a by-pass oil cleaning unit or it can be used as a mobile
8.TY Series mobile machines are fitted with pump / motor,
pre-heater, vacuum pump etc
to clean oil in the parent machine oil tank or outside it in drums
or other reservoirs.
3.How Does The Turbine Oil Cleaning Works:
When the machine start, oil is flowed into primary filter under the
difference pressure between inside and outside and big impurities
After heating, oil flow into secondary filter. Then oil flow into
water separator after small impurities are removed.
The water separator adopts a special skill which changes the
impaction of oil and water to speed up trace water and coagulate
which is separated from oil and stored in water content.
Oil is purified again by fine filter, the flows into vacuum pump
which use stereo-evaporation removing left trace water.
Vaporized water was drained away by cooler or vacuum system.
When the oil was transported out by oil pump, the purification
process has finished.